blog -> BMS Systems
|
<span title="RT-BMS Master Power-up Sequence">RT-BMS Master Power-up Sequence </span>
|
|
|
RT-BMS Master Power-up Sequence When the power source is connected, the RT-BMS Master units performs the power-up sequence. During the power-up sequence the RT-BMS Master unit checks all the possible modules addressing, counting from 000 to 064, 128 or 192. (In this demo it is 128). Then it displays the total number of modules found. (In this demo it is 004). After the power-up is finished the RT-BMS Master unit turns off into the Stand-by mode. The Stand-by mode is controlled by the “System switch On/OFF” - the F connector. | |
|
|
|